LAN Manager Workstation/Server

   Introduction:
   -------------
   This document describes the procedure to setup LAN  Manager 2.1
   Workstation/Server driver for REALTEK RTL8139 Fast PCI ethernet adapter.

   Location of Driver:(DOS) \NDIS\DOS\RTSND.DOS
                      

   Sample Configuration Files:
   ---------------------------
      CONFIG.SYS (for DOS will contain):

          DEVICE=C:\LANMAN.DOS\DRIVERS\PROTMAN\PROTMAN.DOS /I:C:\LANMAN.DOS
          DEVICE=C:\LANMAN.DOS\DRIVERS\ETHERNET\RTL8139\RTSND.DOS


          PROTOCOL.INI (will contain):


         [RTL8139]
         ; RTL8139 RPOTOCOL.INI SAMPLE
         DriverName=RTSND$
         EtherID=@0000B4000001  ;This  keyword is used to desinate a RTL8139
                                ;adapter by assigning its ethernet ID
                                ;when more than one adapters exist on one
                                ; system.

         BusNo=@00          ;This  keyword is used to desinate a RTL8139
                            ;adapter by assigning it's PCI bus number
                            ;when more than one adapters exist on one
                            ; system.(must be used with 'DeviceNo' keyword)

         DeviceNo=@0A       ;This  keyword is used to desinate a RTL8139
                            ;adapter by assigning it's PCI Device number
                            ;when more than one adapters exist on one
                            ; system.(must be used with 'BusNo' keyword)

         Speed= 100/10      ;This keyword is used to force RTL8139 adapter
                            ;to speed 10M or 100M mode. If not present,
                            ;the driver will auto-detect the speed.



   Setup driver procedures on LAN Manager workstation/server :
   -----------------------------------------------------------
      Before you start with the installation process, make sure that the
      adapter  is properly  installed  and  configured. Make  sure  your
      Microsoft LAN Manager is properly installed.

      1. Run the appropriate Microsoft Lan Manager SETUP for computer you
         are setting up.(DOS). Select "Configuration"
         item ,(the Realtek driver isn't included on the Lan Manager disk)
         and insert the Realtek  RTL8139  driver disk,  select the Realtek
         driver and follow the directions.

      2. When completed, reboot your computer.


       Installing Multiple LAN Adapters:
   ----------------------------------

          To Follow Setup driver Procedure and add two adapter,

          Under  DOS  mode, you can modify the EtherID or BusNo+DeviceNo
            Keyword field in file C:\LANMAN\PROTOCOL.INI.


                                                        -- Jack Chen --